Introduction

Program Interface

Program Menu

Doing DODA Pure Tone

Doing DODA Speech

Using Audiogram Plotter

Doing DODA Visual Response

Doing DODA Sound

 Introduction

Program Interface - download DODA 4 MOBILE GUI

Program Menu - download DODA 4 MOBILE GUI

USING DODA Pure Tone

1. Click File, Pure Tone Audiogrammer
2. Select the green oval button and click
3. Adjust the sound volume up and down till it is just heard by the person being tested
4. Enter the volume heard for that frequency into the yellow textbox
5. Click the OK button
6. Repeat same procedures 2 to 5  for the red, orange, yellow and blue buttons respectively
7. Then click the Plot button
8. Select any of the arrows pointing in the direction of the ear you have just measured
9. click Save button to save the Chart fro that ear
10. Click Reset button
11. Repeat the procedures 2 to 9 for the other ear
12. Click Report to report on the audiogrammer results after testing each ear

Doing DODA Speech

1. Click File, Speech  Audiogrammer. Alternatively Click the button labeled Speech
2. Select the Sound tab labeled Sounds 1-5
3. Click on Button 1
4. Adjust the sound volume up and down till it is just heard by the person being tested
5. Enter the volume at which word was just heard in the yellow textbox, and the word heard in the white textbox
6.  Click OK button
7. Repeat steps 2 to 6 for buttons 2 to 20
8. click Plot and Select the arrow pointing to the ear just tested
9. Click the Score button on the lower right corner of the screen to score the speech test
10. Click report to obtain a report of the test just carried out
11. Click Reset button
12. repeat steps 2 to 10 for the other ear